Remember, White wires connect to Silver screws and Black wires connect to Brass Screws. Re-strip and connect the power supply wires to the terminals marked “LINE” and the downstream wires to the terminals marked “LOAD”.Turn the power back off and re-tape the breaker in the panel box to avoid accident re-activation.Use a circuit tester to determine which set of wires is “hot” (the “LINE” wires).(These allow the GFCI to work as intended and protect all the outlets on the “LOAD” side.) To do this, make certain the wires are completely separate from one another (and not touching any ground) then turn the circuit breaker back on in the panel box. At this point when wiring a GFCI outlet, you’ll need to note which wires are the power supply “LINE” wires and which are the downstream “LOAD” wires.Specific Installation Steps for Wiring a GFCI Outlet: GFCI receptacle – The LOAD terminals are only used if you are passing power through the GFCI to protect additional receptacles downstream. The clock radio or light should come back on. Reset the GFCI by pressing the “Reset” button on the outlet until it clicks into place.If the radio turns off, the outlet is working. Test the GFCI by pressing the Black “Test” button on the outlet.Plug a clock radio or light into the outlet.Turn the power back on at the circuit-breaker panel.Replace the receptacle, screw it back into the box, and attach the cover plate.Connect the bare ground wire to the green (Ground) screw. Remember, the White wire connects to the Silver LINE screw and the Black wire connects to the Brass LINE screw. Re-strip and re-connect the power-supply wires to the terminals marked “LINE”.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |